Advertisement
PARTS
7. Screws (x4)
8. Water connection: (WATER)
9. Foam fl uid connection (FOAM)
10. Fluid tap
11. Absorption tube for foam fl uid.
12. Inlet Water tap
ASSEMBLY AND OPERATION
1-
Assembling: To assemble the acquired FX head, you must previously remove the Sky
dancer head supplied from the turbine by loosening and removing the screws
Fix then the Foam generator head on the turbine using the supplied screws, and lining up the
4 holes. Place the machine in the intended place, either on a tripod or hung. In case of use of
a tripod, make sure that it can hold at least 50 kgs. Adjust the inclination of the machine and
tighten the locking knobs.
2-
For operation of the foam generator, please refer to the section "assembly and
operation" of Sirocco foam cannon (pages 6-9) as it works in the same way. The diff erence
is that with the foam generator, the foam is not projected at distance, but will fall down from
the foam head.
FREQUENT ASKED QUESTIONS (FAQ)
•
The generator does not create foam, or just a small amount.
If the machine is correctly connected as described in assembly section, then the problem
is because it doesn't arrive enough foam fl uid to the generator. If you have the machine
hung at a certain height, make sure that you have enough water pressure so that the
machine can suck the foam fl uid up to the height of the machine. Either, raise the carafe of
foam fl uid up to the height of the generator. If this is not possible, then you need to use a
water tank with foam fl uid diluted inside and pump this mixture up to the machine, via the
PREMIX connection.
Detail of connections
12
INSTRUCTION MANUAL
Advertisement
