Advertisement
4) Press
some (probably incorrect) thickness value, the "H1" symbol will appear on the
display, and the "mm" or "in" symbol will start flashing (Fig. 11).
5) Remove the transducer from the 1
6) Using
it matches the actual (true) thickness of the 1
7) Press
and the "H1" symbol will change to "H2" (Fig. 12).
ATTENTION!
The thickness difference between the 1
less than 2 mm. If the thickness difference is less than 2 mm, an error message will be
displayed.
8) Press the transducer against the 2
wetted with couplant, making sure that the transducer sits flat against the surface of
the 2
sample. The Stability Indicator should have nearly all vertical bars on.
nd
9) Press
thickness value, and the "mm" or "in" symbol will start flashing.
10) Remove the transducer from the 2
11) Using
it matches the actual (true) thickness of the 2
key on the keypad, after which the main indicator will show
and
keys, adjust the displayed thickness up or down, until
key, after which the "1-OK" symbol will appear on the display,
key, after which the main indicator will show the current
and
keys, adjust the displayed thickness up or down, until
Fig. 11
sample piece.
st
sample piece.
st
Fig. 12
and 2
sample pieces should not be
st
nd
sample of a known thickness prior
nd
sample piece.
nd
sample piece.
nd
20
Advertisement
