Side Door Installation; Front Door Installation; Grounding - Lanberg WF01 64 V2 Series User Manual

4. Side door reinstallation
1. Side doors, which should have been removed from the box at
an earlier stage of assembly, should be reinstalled in the side
frames [B + C]. Simultaneously press 2 latches in the middle of
doors, and when they are aligned with the frame holes, release them.
2. Use the keys [P] to lock the side frame door.

5. Front door installation

1. Put a plastic washer [N] on one of the bottom cover holes [R] on
which you plan to place the grounding pin of the front door [A].
2. Insert the lower pin of the front door [A] into the lower hole
through the plastic washer, and then insert the upper pin into
the hole on the top cover [D] by pressing the hinges (L-shaped)
inwards. Release the pressure when it is aligned with the hole.
3. Use the keys [O] to lock the front door.

6. Grounding

The cabinet has 4 grounding pins with a diameter of 6 mm:
• 2x on the front door [A].
• 2x on the bottom cover [R].
Grounding wire [M] is included. It consist of 42 conductors made of pure copper (100% CU), 0.16 mm each. The cable cross-section is
~0.9 mm2. A cable is used to connect the bottom cover to the front door (with the possibility of opening it at an angle of up to 180°).
To connect one of the cabinet's main grounding pins (located on the bottom cover) to the equalizer connection a cable of appropriate
length must be purchased separately. Its AWG should be between 17 ~ 18 and the conductors must be made of pure copper (100% CU) only.
22
Lanberg © 2015-2021 EN