Lanberg WF01 64 V2 Series User Manual page 19

3. Place the top cover [D], with cable entry at the back, on the side frames [B + C], and adjust it to their alignment.
4. Use a total of 4 M6*12 Phillips screws [K] to attach the top cover to the side frames - 2 on each side.
i
Remember to:
I) Regularly pay attention to the position of the top cover [D] in regards to the holes in the side frames [B + C]. Do not tighten every
screw to the max! First, insert all of them at about 2/3 of their height, check the alignment, and then tighten all screws.
II) Make sure that the small holes for M4*8 self-tapping Phillips screws [I] on the front side of both covers and side frames overlap
with each other.
5. Rotate the whole structure 180 degrees. Adjust the bottom cover [R] to the side frames position.
6. Use a total of 4 M6*12 Phillips screws [K] to attach the bottom cover to the side frames - 2 on each side.
EN Lanberg © 2015-2021
19