Rear Cabinet Cover Installation; Flat Blank Panels Installation - Lanberg WF01 64 V2 Series User Manual

Remember to:
i
I) Regularly pay attention to the position of the bottom cover [R] in
regards to the holes in the side frames [B + C]. Do not tighten every screw
to the max! First, insert all of them at about 2/3 of their height, check the
alignment, and then tighten all screws.
II) Make sure that the small holes for M4*8 self-tapping Phillips screws [I]
on the front side of both covers and side frames overlap with each other.
7. Use a total of 4 M4*8 self-tapping Phillips screws [I] to fix, on the front
side, both covers [D + P] with side frames [B + C] - 1 on each side (see
the illustration above).

2.2.5. Rear cabinet cover installation

1. Align the rear cover [F] so that its 6 holes overlap with the 6 holes at the rear of the side frames [B + C].
2. Use a total of 6 M4*8 self-tapping Phillips screws [I] to attach the rear cover to the side frames - 3 per side.

2.2.6. Flat blank panels installation

1. Align flat blanking panel [E] to the cover's lower cable entry so that the screw holes on both components overlap.
2. Use a total of 2 M4*8 self-tapping Phillips screws [I] to attach the blanking panel to the lower cable entry - 1 per each side.
3. Rotate the cabinet structure by 180 degrees.
4. Align another flat blanking panel [E] with the cover's upper cable entry so that the screw holes on both components overlap.
5. Use 2 more M4*8 self-tapping Phillips screws [I] to attach the blanking panel to the upper cable entry - 1 per each side.
20
Lanberg © 2015-2021 EN