Mounting And Set-Up - Vents Boost 355 User Manual

MOUNTING AND SET-UP

BEFORE MOUNTING, MAKE SURE THERE ARE NO VISIBLE DEFECTS ON THE UNIT, SUCH
CONTACT WITH HAZARDOUS ZONES OF THE FAN BY INSTALLING AIR DUCTS OF THE
The unit is intended for mounting with round air ducts. The fan is installed between the air ducts.
The fan casing is equipped with fixing brackets for suspended mounting or for mounting on a horizontal or vertical surface.
While installing the unit ensure convenient access for subsequent maintenance and repair. Fasteners for fan mounting are not included
in the delivery set and should be ordered separately. While choosing fasteners consider the material of the mounting surface as well as
the weigh of the unit, refer to the Technical data section. Fasteners for unit mounting should be selected by a service technician.
The unit can be mounted in two operation positions, which makes mounting easier. For this, dismantle the fan handle first or set it to
another position.
After choosing one of two positions, securely mount the brackets to the fan.
1.
Install the fan on the threaded rods (not included in the delivery set).
WARNING! When mounting the fan on threaded rods, it is necessary to provide protection of the nuts against
self-loosening.
www.ventilation-system.com
READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.
AS MECHANICAL DAMAGES, MISSING PARTS, IMPELLER JAMMING ETC.
WHEN MOUNTING THE UNIT, IT IS NECESSARY TO PROVIDE PROTECTION AGAINST
NECESSARY LENGTHS AND PROTECTIVE GRILLES.
MOUNTING MUST BE PERFORMED BY QUALIFIED SPECIALISTS ONLY, PROPERLY
TRAINED AND QUALIFIED TO INSTALL AND MAINTAIN VENTILATION EQUIPMENT.
2.
Nut
Washer
Vibration absorbing
rubber
Washer
Nut and lock nut
Threaded rod
SUSPENDED MOUNTING
7