If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Defective power cables pose a serious health risk! cordless work light PWLS 10 / PWLS 10-20V...
Page 3
Please observe the The battery contains irritating, caustic and toxic instructions for cleaning and maintenance. substances that pose significant risks to people and the • The charger is only suited for indoor use. environment. cordless work light PWLS 10 / PWLS 10-20V...
The device PWLS 10-20V is supplied without battery and quick charger as accessories. You may use Trotec Warning Multiflex batteries 20V 2 Ah / 4 Ah and the Dangers can occur at the device when it is used by...
Page 5
Quick charger blowing) Scope of delivery Charging time Cable length 1.5 m PWLS 10 • 1 x Cordless work light Protection class II / • 1 x Belt clip • 1 x Manual cordless work light PWLS 10 / PWLS 10-20V...
When the device is not being used, observe the following storage conditions: • dry and protected from frost and heat • Ambient temperature below 40 °C • protected from dust and direct sunlight cordless work light PWLS 10 / PWLS 10-20V...
I.) and pulling the battery off the device (II.). 90° 180° 180° 2. If required, charge the battery (8) as described in the section Charging the battery. cordless work light PWLS 10 / PWLS 10-20V...
• Check the power cable and mains plug for damage. • Check the on-site fusing. • Check the quick charger for damages. Should the quick charger be damaged, stop using it. Contact the Trotec customer service. • Check the battery terminals for dirt. Remove any dirt.
• Dry the device with a soft, lint-free cloth. • Keep the connecting terminals on the device and charger clean. cordless work light PWLS 10 / PWLS 10-20V...