Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PWLS 01-3
Summary of Contents for Trotec PWLS 01-3
- Page 1 PWLS 01-3 ORIGINAL INSTRUCTIONS LED WORK LAMP...
-
Page 2: Table Of Contents
Information marked with this symbol indicates that the • If operating a power tool in a damp location is instructions must be observed. unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. LED work lamp PWLS 01-3... - Page 3 Any other use than the one described in the chapter "Intended use" is regarded as reasonably foreseeable misuse. Personnel qualifications People who use this device must: • have read and understood the instructions, especially the Safety chapter. LED work lamp PWLS 01-3...
-
Page 4: Information About The Device
Caution Keep a sufficient distance from heat sources. Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. LED work lamp PWLS 01-3... - Page 5 3 x 1.5 V, AA batteries Permitted ambient temperature (when -30 °C – +75 °C stored) Designation Operating temperature -20 °C – +55 °C Surface LED On/off switch Battery compartment Spotlight LED Hook Flashing warning light button Magnetic holder Mounting bracket LED work lamp PWLS 01-3...
-
Page 6: Transport And Storage
• protected from dust and direct sunlight 1. Open the battery compartment (3) at the front of the device by pulling down the battery compartment cover (3). 2. Insert the batteries with correct polarity (+/-). 3. Close the battery compartment (3). LED work lamp PWLS 01-3... -
Page 7: Operation
LED (4) back off again. ð The spotlight LED (4) is no longer illuminated. 2. Press the on/off switch (2) 1 x again and hold it for 2-3 seconds to switch on the surface LED (1). ð The surface LED (1) is illuminated. LED work lamp PWLS 01-3... -
Page 8: Errors And Faults
• Check the contacts in the battery compartment. Remove any dirt. Flashing warning light • The LEDs may be defective. Contact the Trotec customer 1. Press the triangular flashing warning light button (6) 1 x to service. use the device as flashing warning light. -
Page 9: Maintenance
• Dry the device with a soft, lint-free cloth. Batteries and Accumulators Regulations 2009 (SI 2009/890) (as amended), devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. LED work lamp PWLS 01-3... - Page 10 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...