Bristan Java Fitting Instructions page 2

WATER PRESSURE
These taps are suitable for use at all supply pressures. If the taps are
installed at low pressure (tank fed), then the minimum height from the
outlet of the nozzle to the underside of the cold tank should be 1.8
metres to ensure adequate performance.
These taps should be installed in compliance with Water Regulations.
For further details contact your Local Water Authority.
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Install the taps into the basin, bath or sink, using the washers and
backnuts provided.
3. Connect the hot and cold water supplies.
4. Turn on the water supplies. Open both taps letting the water flow for
a few minutes to flush the system.
5. Check all joints and connections for leaks.
6. See over the page for aftercare instructions.
PRISE OFF CAP
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Prise off cap, loosen grub screw with 2.5mm hexagon key and pull off
head.
3. Remove valve.
4. Carefully clean seating, rubber washer and ceramic disc.
5. Replace valve and head and turn on the water supply.
6. Contact our helpline if problem persists.
CD VALVE
Please note: In the unlikely event you find a part missing please
contact our Customer Service Helpline on 0844 701 6273 or email
enquire@bristan.com for immediate dispatch of part.
CLEAN WASHER
AND SEAT