Installation - Husqvarna W50P Operator's Manual

To install the suction hose to the
product
1. Attach the hose connector (A) to the suction hose
(B) with a hose clamp (C). Make sure that the
sealing washer for the hose connector is in good
condition.
F
A
A
C
B
2. Install the strainer (D) at the end of the suction hose
with the hose clamp (E).
3. Tighten the hose connector on the pump suction
inlet (F).
Introduction
WARNING:
safety chapter before you install the product.
To install the product
1. Put the product on stable and level ground near the
water surface.
2. Make sure that the product has a free space of a
minimum of 1 m.
3. Make sure that there are no flammable objects near
the engine.
1421 - 004 - 09.07.2020
C
B
E
D

Installation

Read and understand the
To install the discharge hose
1. Attach the hose connector (A) to the pump outlet.
2. Install the discharge hose (B) to the hose connector
and tighten the hose clamp (C).
4. Make sure that the level difference for the suction
hose (A) is as low as possible for the operation. The
level difference for the suction hose must not be
more than 7.5 m/25 ft.
B
A
Note:
The level difference for the discharge hose
(B) can be more if it is necessary. But, a lower total
level difference (C) gives the best result.
A
C
B
C
7