Semtech XE8000 ProStart II User Manual page 31

Possible causes : 1 Is an Evxxx board connected to the programming connector?
2 If the answer on point 1 is yes does the Prog LED blink shortly during the read? If not verify
if your power supply can deliver at least 1Amp. If it's still not working, the board must be
shipped back to your SEMTECH representative.
3 Are your XELoader & Firmwares up to date? see on
© Semtech 2006
XE8000 ProStart II
http://www.semtech.com
31
User Guide
www.semtech.com