4.10 Changing Target Power Supply; 4.11 Getting The Xe8000 Checksum; Enabling / Disabling The Rs232 Line Driver (Port B 6/7) - Semtech XE8000 ProStart II User Manual

4.10 CHANGING TARGET POWER SUPPLY

D:\Projet\XELoader\Release> XELoader 2 COM2 -s 5.0 -c
Sending ProStartKit supply voltage...
ProStartKit power supply set to 5.0
D:\Projet\XELoader\Release>
Note: This option is available for both generations of ProStart

4.11 GETTING THE XE8000 CHECKSUM

D:\Projet\XELoader\Release> XELoader 2 COM2 –g -c
Reading target chip checksum...
XE8000 CheckSum
Checksum Read OK!
D:\Projet\XELoader\Release>
Note: This option is only available for the second generation of ProStart (ProStart II)

4.12 ENABLING / DISABLING THE RS232 LINE DRIVER (PORT B 6/7)

Note: This option is only available for the first generation of ProStart
Note: For the ProStart II the enable / disable of the RS232 line driver is managed by hardware, simply connecting
a RS232 DB9 cable to the connectors enables the line driver
D:\Projet\XELoader\Release> XELoader 2 COM2 -r ON -c
Sending port B behavior...
D:\Projet\XELoader\Release> XELoader 2 COM2 -r OFF -c
Sending port B behavior...
D:\Projet\XELoader\Release>
© Semtech 2006
: 0x122556
XE8000 ProStart II
18
User Guide
www.semtech.com