Electrical Parameters; Programmer Parameters; Table 1 : Flash Programming Timings - Semtech XE8000 ProStart II User Manual

5.4

ELECTRICAL PARAMETERS

Power supply: 9VDC
Current consumption
•
Without Evaluation board connected : 340mA
•
With Evaluation board connected, no LED lit about 360mA
•
During the programming phase peaks up to 550mA
•
Consumption with all the LEDS on 680mA
Please be careful when handling the board, the regulators and the CPLD may be hot !
Values generated by the board
•
High voltage for programming purposes 12VDC
•
VDD for MP and EV boards : 5VDC
•
VDDA for EV boards : 2.4 to 5VDC
Default EV board supply value : 3VDC
Programming supply value : 5VDC
5.5

PROGRAMMER PARAMETERS

The programming of a XE8000 MTP chip is done in 3 phases.
Erasing the flash array
Writing the blocking bits
Writing the data
Timings:
Upload 8k instruction
Best case 1erase 1write
Worst case 5erase 5 write

Table 1 : Flash programming timings

© Semtech 2006
Type I flash
1 min 5 sec
5 min
20
User Guide
XE8000 ProStart II
Type II flash
47 sec
3.35 min
www.semtech.com