Xeloader Command Line - Semtech XE8000 ProStart II User Manual

4.8

XELOADER COMMAND LINE

If the command line version fits your application better, you can still use it this way. Simply add the following option at
the end of the command line : "-c", the GUI will still display but there is no need to interact with it.
C:\>XELoader -c
Usage: XELoader prostart_type comport [-h] | [-i] | [-t target_name] | [-u input_file] | [-s
voltage] | [-g] | [-r state]
Interfaces the XE8000 familly ProStart kits
-h
prostart_type
com_port
-t target_name
-i
-u input_file
-s voltage
-g
-r state
*** XELoader Version V 3.2 Release date Apr 11 2005
Copyright (c) 1997-2004, SEMTECH SA, Monruz 2, CH-2000 Neuchatel, Switzerland
The "-c" option makes the command line program act the same way as previous versions.
© Semtech 2006
: Display this information.
: Specifies the ProStart type
1 for ProStartI
2 for ProStartII
: Specifies the com port (COM1, COM2, ...)
: Specifies the target chip to upload
: Display information about XELoader and connected
ProStartKit.
: Uploads input_file to the XE8000 microcontroller
Input file formats : *.axe, *.bin, *.rom
: Sets the given voltage on the ProStart
Voltage : 2.4, 3.0, 5.0
: Reads the XE8000 microcontroller Checksum
(only for ProStartII)
: Enables or disables the PortB pins 6 and 7
connection to the RS232 line driver.
state : ON, OFF (only for ProStartI)
14
User Guide
XE8000 ProStart II
***
www.semtech.com