Troubleshooting - Adaptec APD-2930 User Manual

6 Connect other external SCSI devices by cabling each device to
the previous one, as shown. Terminate only the SCSI device at
the end of the chain.
Unterminated devices
Terminated device
7 Connect all power cables to the external SCSI devices and the
computer.
8 Turn on all external SCSI devices and allow them to power up.
Then turn on the computer.
9 Install any software included with your SCSI devices.

Troubleshooting

If you encounter any problems after installation, check the
following items first:
Are all SCSI devices powered on?
I
Are all SCSI cables and power cables properly connected?
I
Is the PowerDomain 2930 firmly seated and secured in the PCI
I
expansion slot? Turn off the power before checking the card.
Does each device on the SCSI bus have a unique SCSI ID?
I
Is the SCSI chain properly terminated? Refer to your device
I
documentation and to the related sections in this User's Guide.
If you are still unable to resolve a problem, refer to the Adaptec
Web site at http://www.adaptec.com for additional troubleshooting
information and direction.
Troubleshooting
12