Table of Contents
Advertisement
3
Turn
ON
the computer.
In most cases your computer, host adapter, and SCSI
peripherals are now ready to use.
Booting the Computer
The AVA-1505 does not provide booting capability. If
you want to boot from a SCSI drive installed on the
host adapter, you can install an AVA-1515, which
provides booting capability.
6
Software Installation
DOS/Windows Platforms
For installing software, insert the software diskette
into a floppy diskette drive, change to the drive letter
of that drive (either A or B), and type install and press
Enter. Then follow the instructions onscreen or in the
software documentation.
Remember the software and hardware settings for
interrupt channel and port address must match, see
Section 4, Installing the Host Adapter, and Section 8,
Jumper Block Settings.
Note:
If you change the interrupt channel or
the port address jumper setting after install-
ing the software, you may need to reinstall
or reconfigure the software. See the software
documentation.
7
Troubleshooting Checklist
If you have a problem during installation, check
these items first:
Are all SCSI peripheral devices powered? Did
you power them before system boot?
Are all SCSI bus cables and power cables properly
connected?
Do the host adapter and all devices on the SCSI
bus have unique SCSI IDs?
Are all devices on the SCSI bus terminated prop-
erly? (See Section 5, Connecting Peripherals.)
the power for the peripheral(s) then for
5
Advertisement
Table of Contents
