1
Getting Started
This guide tells you how to install and configure
™
the AVA
tion instructions are given in Sections 4 through 8.
2
Board Layout
This figure identifies the major AVA-1505 compo-
nents, and the table describes each component.
Location
1
J1
1
J5
1
J6
F1
RN1, RN2, RN3
U3
1
Pin 1 is marked by 1 on the board.
3
Default Settings
The AVA-1505 is designed to operate as shipped in
most AT-class computers. The default settings are
Parameter
SCSI Disconnection
SCSI Address
SCSI Parity
Terminators
Terminator Power
Interrupt Channel
AT Port Address
1
These values are set by the software (see Section 6, Software Installation).
2
See Section 8, Jumper Block Settings, to learn how to change these settings.
®
-1505 AT
1
1
1
1
2
2
-to-SCSI host adapter. Installa-
Description
Jumper Block
50-pin Internal SCSI Connector
DB25 External SCSI Connector
Fuse
Terminators
AIC-6360 PIO Chip
Default Setting
Enabled
7
Enabled
Installed
Supplied by host adapter
11
340h-35Fh
1