Towing - Ferrari Portofino Manual

• Loosen the five wheel stud bolts approximately one turn each using
wrench D supplied.
• Place the base of the jack E on flat firm ground under one of the jacking
points F on the underfloor as shown in the figure.
• Raise the vehicle carefully using jack
Warning
If the jack is not positioned correctly, the vehicle could slip off. Make
sure that no part of the body is underneath the vehicle while changing
the wheel. The supplied jack must only be used for changing wheels.
• Unscrew the five stud bolts and remove the wheel.
• Fit the uninflated collapsible spare wheel.
• Screw the stud bolts into place but do not tighten them.
Important note
Inflate the collapsible spare wheel before lowering the vehicle to avoid
damaging the rims.
F
E
D
E until the wheel is off the ground.
• Inflate the collapsible spare wheel using the inflation kit.
Important note
The kit must be used in "tyre inflation" mode. Refer to the instruction
manual supplied with the kit.
• Inflate the spare wheel to the indicated pressure.
• Lower the vehicle and remove the jack.
• Tightly fasten the stud bolts, alternately going from one stud bolt to one
that is diametrically opposite.
As soon as possible, tighten the stud bolts with the torque wrench to a
torque of 100 Nm.

Towing

When towing the vehicle, avoid using anchor points that are not designed
for the tow hook inserted in housing B.
Proceed as follows:
●
Take the tow hook out of the tool kit;
●
Remove the cap B;
●
Tightly screw the tow hook into the correct housing;
●
Release the EPB;
●
Release the Park Lock.
Warning
If there is an electrical system failure, release the EPB and Park Lock
manually.
ADVICE FOR EMERGENCY SITUATIONS
4
171