Seat Adjustment - Ferrari Portofino Manual

●
the engine compartment lid is open;
●
automatic engine restarting has not been successful;
●
a failure has been detected that may interfere with operating of the
Stop&Start system.
At times, depending on the seriousness of the failure, the ENGINE START
button may have to be held down for a few seconds to restart the engine:
this condition is indicated on the left TFT display by the message "Press
and hold ENGINE START button to start".
System failure
If malfunctioning, the Stop&Start system is disabled. The driver is
informed of the failure by a special symbol that appears on the left
TFT display for 20 seconds accompanied by an acoustic signal and the
following message which corresponds to two different alarm levels:
●
"Stop&Start failure" (orange symbol)
●
"Stop&Start failure. Go to dealer" (red symbol)
Important note
Contact the Ferrari Service Network immediately.
When the display cycle ends (20 seconds), or the MODE button with
"ESCAPE" function is pressed, the message disappears and the symbol
is reduced to an icon.
Precautions to be taken during maintenance work
Switch off the instrument panel before carrying out any repair and/or
maintenance work on the vehicle. If work has to be carried out on the
vehicle with the instrument panel activated, check that the Stop&Start
has been deactivated before doing any repair and/or maintenance work.
Check that the message "Stop&Start OFF" appears on the left TFT
display for 5 seconds. The button LED must be ON.
ABOUT YOUR VEHICLE
138
Warning
NEVER work on the vehicle if the message "Stop&Start active"
appears on the left TFT display.

Seat adjustment

Warning
As with all adjustment, seat adjustment must be performed when the
vehicle is stationary.
Warning
Never place your hands under the seat or near its moving parts when
adjusting. If you do so, movement of the seat may cause injury to
hands or fingers.
Correct adjustment is very important for enhanced driving comfort and
maximum efficiency of the passive safety systems.
The seat position can be electrically adjusted using the special controls.
Three adjustments are possible using control D:
●
backward/forward adjustment
●
height adjustment
●
seat inclination (tilting)
Warning
Forward/backward adjustment must take into account the fact that
airbag devices are placed in front of the driver and the passenger.