Venue Tetra Beam Manual page 6

S
IR Remote Controls
OFF: Turns Tetra Beam off
ON: Turns Tetra Beam on
AUTO: Sets patterns to cycle automatically at a rate controlled by the
SPEED+/SPEED- controls
SOUND: Sets pattern changes based on input from the MIC (#3 on the
rear panel)
STROBE: Turns the strobe effect on or off. When STROBE is on, SPEED+
and SPEED- controls control the strobe pulsing speed
SPEED-: Decreases the speed of the strobe pulsing when in STROBE
mode, and decreases the speed of the pattern changes when in AUTO
mode
SPEED+: Increases the speed of the strobe pulsing when in STROBE
mode, and increases the speed of the pattern changes when in AUTO
mode
COLOR: Puts Tetra Beam in manual color mode, where R1-R4, G1-G4 and
B1-B4 buttons can be used to control colors for each individual beam.
When in color mode, pressing the COLOR button will clear all active LEDs
R1-R4: Turns red LEDs on or off for the associated beam
G1-G4: Turns green LEDs on or off for the associated beam
B1-B4: Turns blue LEDs on or off for the associated beam
enuelightingeff