11. There are three issue modes available on this printer. How to set the media for each mode is provided below.
Batch mode
In the batch mode, the media is continuously printed and fed until the number of labels/tags specified in the issue
command have been printed.
(1) Pull the media past the media outlet.
Turn the Pinch Roller Lever counterclockwise to lock the Pinch Roller.
Media Outlet
(2) Close the Top Cover and Right Side Cover.
Strip mode (Option)
When the optional Strip Module is fitted, a label is automatically removed from the backing paper at the Strip
Plate as each label is printed.
(1) Pull out the backing paper past the Media Outlet.
Media Outlet
Backing Paper
Strip module
(2) While holding down the Backing Paper Release Bar, and pass the backing paper between the Backing Paper
Holder and the Strip Roller. Then, release the Backing Paper Release Bar.
Backing Paper
Backing Paper
Release Bar
(3) Turn the Pinch Roller Lever counterclockwise to lock the Pinch Roller.
Close the Top Cover and Right Side Cover.
Pinch Roller Lever
WARNING!
When the Backing Paper Release Bar is released, it is
automatically closed by the spring. Care must be
taken not to pinch your fingers or hands.
ATTENTION!
Lorsque vous relâchez la barre du contre rouleau, un
ressort la ramène automatiquement en position.
Attention de ne pas vous faire pincer les doigts ou
les mains.
6
Pinch Roller Lever
Strip Roller
Backing Paper
Holder
Top Cover
Right Side Cover