Fcc, Acta And Ic Regulations - VTech Analog Contemporary Series Master User Manual

Appendix

FCC, ACTA and IC regulations

FCC Part 15
This equipment has been tested and found
to comply with the requirements for a Class
B digital device under Part 15 of the Federal
Communications Commission (FCC) rules.
These requirements are intended to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications to this equipment
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This Class B digital apparatus complies with
Canadian ICES-003.
FCC Part 68 and ACTA
This equipment complies with Part 68 of the
FCC rules and with technical requirements
adopted by the Administrative Council for
Terminal Attachments (ACTA). The label on the
back or bottom of this equipment contains,
among other things, a product identifier in
the format US:AAAKXNANXXXX. This identifier
must be provided to your telephone service
provider upon request.
The plug and jack used to connect this
equipment to premises wiring and the
telephone network must comply with
applicable Part 68 rules and technical
requirements adopted by ACTA. A compliant
telephone cord and modular plug is provided
with this product. It is designed to be
connected to a compatible modular jack that
is also compliant. An RJ11 jack should normally
be used for connecting to a single line. See the
installation instructions in the user's manual.
The Ringer Equivalence Number (REN) is
used to determine how many devices you
may connect to your telephone line and still
have them ring when you are called. The
REN for this product is encoded as the 6th
and 7th characters following the US: in the
product identifier (e.g., if ## is 03, the REN
is 0.3). In most, but not all areas, the sum of
all RENs should be five (5.0) or less. For more
information, please contact your telephone
service provider.
This equipment may not be used with Party
Lines. If you have specially wired alarm dialing
equipment connected to your telephone
line, ensure the connection of this equipment
does not disable your alarm equipment. If you
have questions about what will disable alarm
equipment, consult your telephone service
provider or a qualified installer.
If this equipment is malfunctioning, it must
be unplugged from the modular jack until
the problem has been corrected. Repairs to
EN - 23