EGO POWER+ ST1510T Operator's Manual page 30

PROBLEM
The cutting line
cannot be wound
into the trimmer
head properly.
The cutting line
cannot be passed
through the trimmer
head when insert-
ing the line.
30
56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1510/ST1510-FC
CAUSE
◾
The cutting line is too long.
◾
Improper cutting line is
used.
◾
Grass debris or dirt has
accumulated in the
trimmer head and blocked
the movement of line
spool.
◾
Motor is overheated due to
repeatedly operating the
line winding system.
◾
Low battery.
◾
The cutting line is split or
bent at the end.
◾
The lower cover is not
released to position after
reinstalling.
SOLUTION
◾
Cut the line so that about 5.5
in.(14cm) long is showing on each
side.
◾
We suggest that you use EGO
original nylon cutting line,
see"Recommended Cutting
Line"section in this manual. If using
EGO nylon line and the problem
persists, please call EGO customer
service for advice.
◾
Remove the battery, open the
trimmer head and clean it
thoroughly.
◾
Let the string trimmer work under
no load for a few minutes to cool the
motor, then try to reload the line.
◾
Charge the battery.
◾
Cut the worn end of line and reinsert.
◾
Attach the battery pack onto the
trimmer; press the line loading
button to briefly start the power
loading to release the lower cover.