Description Micromaster 411 & Combimaster 411 Em Brake Option; Introduction - Siemens MICROMASTER 411 Operating Instructions Manual

УП "Спецпривод-С". http://www.privod.by/. Email: info@privod.by, msv125@mail.ru
Адрес: Республика Беларусь, г.Полоцк, ул. Гагарина 8, комн. 304.
Телефоны: 8 (0214) 444395, 443688, 442155, (029) 6171554
Issue 03/02
1 Description MICROMASTER 411 &
COMBIMASTER 411 EM Brake Option
1.1

Introduction

The Electromechanical Brake Control is housed within an Options module attached
to the side of the inverter. Full IP66 environmental protection is maintained.
The Electromechanical Brake Control module provides an output to the drive coil of
a DC electromechanical brake. The unit is configured using parameters P1215,
P1216 and P1217, which allows for full control of brake release and brake
application times. The Brake Coil voltage is configured via jumpers settings within
the unit.
The brake is applied when the supply is disconnected from the solenoid coil and is
released when the solenoid coil is energized. The solenoid coil is energized by a
DC voltage.
The unit is capable of providing a short duration 'quick release' brake action via a
full wave supply.
Figure 1-1 shows the layout of the EM Brake Module.
Electromechanical Brake Control Option
6SE6400-5CS00-0BP0
Operating instructions
INSTALLATION
9