Permissible Installation Positions; Motor Housing Regulation - Askoll ENERGY SAVING ES2 Installation And Operation Instructions Manual

Thread Pump housing
material
G1 Composite PA 66 GF
G1 Cast Iron EN-GJL-200
G1½ Cast Iron EN-GJL-200
G2 Cast Iron EN-GJL-200

7.2 Permissible installation positions

Install the circulator with horizontal motor shaft axis (Fig. 7.2).
Fig. 7.2: Permissible installation positions

7.3 Motor housing regulation

Fig. 7.3: Motor housing positions
The motor body can be rotated in the positions shown in Fig. 7.3.
Pay utmost care to prevent people from getting in contact with the hot surfaces
of the circulator.
Drain the system or close the isolating valves on either side of the pump before
the screws are removed. The pumped liquid may be scalding hot and under
high pressure.
Pay attention not to damage the seal of the pump housing.
CAUTION
Tightening torque
Max. 50 Nm
Max. 85 Nm
Max. 125 Nm
Max. 165 Nm
15