Charging The Battery Pack; Installing The Battery Pack; Turning On The Power; Turning Off The Power - Maverick ion Series Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

Charging the battery pack

Always use the included charger for the included battery pack. Charging time for an empty battery pack is about 3
hours. Do not charge the battery pack longer than 4 hours to avoid overheating and battery damage. Always remove
the charger from the mains socket when not in use
Cautions
This charger can be used only for the battery pack included in this kit.
Do not charge the battery pack for longer than 4 hours. Overcharging generates excessive heat and will damage
the battery pack.
Use the charger with adult supervision and do not leave unattended. Do not use the charger near
water or when wet.
Do not use the charger if the wire is frayed or worn. If the wire is frayed or worn a short circuit can
cause a fi re or burns.
If you are unsure of the charge of the battery pack, use it in the vehicle
until the vehicle slows, leave to cool and then recharge.
1. Select your regions electrical mains plug and attach it to the charger. Always use
the correct mains plug version for your country.
2. Connect the charging socket to the supplied battery packs power plug. The
connectors are sided and have a clip to secure it in place. Do not force together
and always check you have the connection the right way round.
3. The charger will automatically start to charge your battery pack. Do not leave
connected for more than 3 hours on a fl at battery pack and always observe the
cautions above.

Installing the battery pack

Turning on the power

Turn on transmitter fi rst and then turn on receiver.
Turn on the transmitter switch and the LED battery indicator will light up.
Turn on the receiver. The automatic set-up of the factory set speed control should
have been completed. If you experience any problems with the speed control settings refer to the Electronic Speed
Control Section for correct setup information.

Turning off the power

Turn off receiver fi rst and then turn off transmitter.
If you switch off the transmitter fi rst before the R/C car, you may lose control of the R/C car.
Turn off the receiver switch.
Turn off the transmitter switch.
Disconnect the battery connector from the speed control connector.
DI SCON N ECT T H E BAT T ERY
PACK AFT ER U SE!
You need to insert the
battery pack in the open
section for the battery. Use
the strap provided to place
on top of the battery and
then use the retaining clip to
secure the battery.
4
Once fastened and secured
please connect the battery
plug into the speed controller
plug noting correct polarity.
Red to red, black to black.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

IonmtIonscIonxbIonxtIondtIonrx

Table of Contents