Page 1
Yaasa Desk Frame Extended Original Operating Instructions...
Page 2
The Yaasa Desk Frame with electronic height adjustment was, alongside common-used tabletops, tested to fulfil the requirements of safety, durability and stability according to EN 527-2:2016 + A1:2019. Yaasa Living AG accepts no liability for damages or injuries that may ensue from incorrect assembly or use of this table.
Page 3
2 minutes. After, the table must “rest” for 18 minutes before it can be operated again. The Yaasa Desk Frame features a collision detection system (Intelligent System Protection, ISP). The ISP Function aims to reduce system damage and injuries through crushing.
Page 4
When the table moves upwards or downwards, you must maintain a safe distance in order to avoid collisions or crushing between the table and its surround objects or persons. The user requires an unobstructed view of the table and its surroundings in order to observe the movement of the table and to avoid collisions, injuries or damages while the table is in movement.
SCOPE OF DELIVERY Package 1 of 1 A 1 x Table Frame B 2 x Table Leg C 2 x Table Foot with Leveler D 2 x Siderail E 4 x Plastic Cover for Siderail F 1 x Operational Control (“Handset”) G 1 x Mains Adapter H 1 x Power Cable 1 x Screw kit with tools...
Page 8
ASSEMBLY INSTRUCTIONS Assemble the table frame strictly according to the instructions. Assembly instructions are included on a separate sheet in the package.
Page 9
XS:a = 1,200 mm - 1,350 mm (47” - 60’’) S: a = 1,350 mm - 1,550 mm (52” - 60’’) M: a = 1,550 mm - 1,750 mm (60” - 68’’) a = 1,750 mm - 2,000 mm (68” - 76’’)
Page 13
The provided screws should be used. The minimum tabletop thickness is 18 mm. Yaasa recommends the use of laminated chipboard or a solid-wood surface. Tabletops with a length of 120 cm to 200 cm and a depth of 70 cm to 80 cm are permitted.
FAQs AND TROUBLESHOOTING Complete troubleshooting instructions and FAQs are available on www.yaasa.eu. FUNCTIONS Changing the table height Press the arrow buttons on the handset in order to move the table upwards or downwards. The table will move as long as the button is pressed or until the minimum or maximum height has been reached.
Page 15
Saving a memory position This function saves a set table height. Each memory position button on the handset can be used to store one position. To save a tabletop position, proceed as follows: Move the table to the desired height (e.g. 73 cm). Press the Save button for a short time.
Page 16
Factory Reset To restore the Yaasa Desk Frame to its factory settings: Hold the following buttons for 3 seconds: (Memory position buttons 1 and 2 and the “Table up” button) The display shows S and a number.
CLEANING Before cleaning or servicing, the table must be disconnected completely from the power outlet. Normal and moderate soiling of the tabletop can be cleaned with a dry paper towel, a clean cloth (dry or slightly damp) or with a non-abrasive sponge (slightly damp).
9001 St. Gallen, Switzerland Person authorized to compile Stephan Egger the technical documents: Yaasa Living AG, President of the Board of Directors St. Leonhardstrasse 45 9001 St. Gallen, Switzerland The manufacturer hereby declares, on its sole responsibility, that the following product:...
Page 20
Yaasa Living AG St. Leonhardstrasse 45 CH-9000 St.Gallen www.yaasa.de www.yaasa.eu 02/2021...