Changing The Limit Values; Picture 43: Statistics - Deprag ME6000 Operating Instruction

Picture 43: Statistics

The limits given in the set-up, if there are any, are used to calculate the CMK value.
Otherwise, the limits from "CMK Settings" (see
NOTE
The machine performance index CM and CMK are first calculated when
more than 5 measurement values have been taken. However evaluation is
only worthwhile after 50 measurements.

11.3.1 Changing the Limit Values

The limit values for the statistics can only be altered if there are no limits entered for the
measurement values (maximum and minimum or target and tolerance) in the set-up. If
limits are already entered for the measurement values and these limits need to be
altered for the calculation of the statistics, then the limit values must be changed directly
in the settings (see
The C and C calculations result from the set limit values. To change the limit values
m mk
click on CHANGE LIMITS.
Set Up).
Changing the Limit
38
Values) are used.