Jumper Setting; Clear Cmos Setup - Acnodes FES 8000 User Manual

Following main board with connector location, which is indicated hardware setup of system.

5.1 Clear CMOS Setup

If you want to clear the CMOS Setup (for example forgot the password you should clear the setup and then set the
password again.), you should close the JP1 about 3 seconds, then open again. Set back to normal operation mode.
By the way, the default setting was remarked.
• JP1: Clear CMOS Setup
JP1
2-3
1-2
Description
Keep CMOS Setup
(Normal Operation)
Clear CMOS Setup
Chapter 5

Jumper Setting

20