Controlling The Cameras - Cisco TelePresence System Profile Series User Manual

Cisco TelePresence System Profile-series, C-series codecs, Quick Set C20
Contents Getting started

Controlling the cameras

During a call, you may control where your own camera is pointing (i.e. pan and tilt)
and the zoom. However, far end systems with remotely controllable cameras may
also permit you to control their camera's panning and zooming. This is called Far end
camera control.
Controlling your own camera (near side)
In a call use the Arrow keys of the remote control to enter the camera
control mode. Softbuttons will now appear as shown below.
Use the Arrow keys and the Zoom keys to pan, tilt and zoom your
camera.
Exit the mode when finished.
Access to far Access to your Access to your
end camera (if
own camera own camera's
far end camera settings.
presets, if
is remotely defined.
controllable).
D14852.01 User guide Cisco TelePresence Profile, C-series codecs, Quick Set C20, July 2011.
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Making calls Phone book usage
Access to your Exit this
own system's mode.
main source
setting.
In-call features In-call features
For video conferences with more than two participants, far end is an ambiguous term.
If you are the initiator of a conference the only far end camera controllable by you will
be the first participant you called. The other participants may all control your camera,
but they cannot control each other.
Controlling far end camera (far side)
In a call use the Arrow keys of the remote control to enter the camera
control mode. Softbuttons will now appear as shown below.
Press the leftmost Function key to access the far end camera.
Proceed as for near end camera control.
Back to near end
camera control.
40
User guide
Advanced settings Contact us
Exit this
mode.
www.cisco.com