Disinfecting The Whirltub System; How Often; How; Sanitary-Grade Acrylic - DURAVIT DuraSquare 760430000AS0000 Operating Instructions Manual

6.1 Disinfecting the whirltub system

How often?

Disinfect the whirltub system before using it for the first time, and then after every
tenth bath, but at least once a month and after a long period of no use.

How?

cAUTIoN
> Observe the safety instructions on the disinfectant label.
> Do NOT bathe in the whirltub while disinfecting it.
> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with water.
> Add 2% chlorine bleach to the water in accordance with the manufacturer's instruc-
tions (approx. 15 ml).
> Turn on the air nozzles for 20 seconds.
> Allow the water in the tub to settle for 5 minutes.
> Turn on the air nozzles again for 20 seconds.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Turn on the air nozzles for 20 seconds.
> Drain the water.
> Wait until the tub has emptied completely.
> The air cleaning process starts after about 2 minutes.
> Wait until the air cleaning process is finished (about 4 mins.).
> Switch off the main switch.
> Repeat the process as necessary.

6.2 Sanitary-grade acrylic

cleaning

> Clean acrylic with a soft damp cloth.
> Use the Duravit Maintenance Set for Acrylic Surfaces for the occasional thorough
cleaning and for removing stubborn spots.
> Remove extensive soiling with warm water and a liquid detergent, dish washing
liquid or soap suds. Do not use anything abrasive as this will cause damage.
20
chlorine bleach irritates the skin.