Advertisement
Available languages
Available languages
EN
■
If you experience an unpleasant sensation while you are using
the product, stop applying it immediately!
■
If a battery leaks, avoid physical contact with the battery acid,
and wear protective gloves if necessary. If you touch bat-
tery acid, rinse the affected areas with abundant clear water
straight away and seek medical assistance immediately.
NOTICE – Risk of Damage to Material and Property
■
Do not immerse the product in water!
■
Keep the product away from sharp and pointed objects.
■
Use only the battery type specifi ed in the "Technical Data".
■
Take batteries out of the product when they are dead or if you
will not be using the product for a prolonged period to prevent
damage caused by leaking.
■
Always replace all batteries together. Do not use batteries of
different types or brands, or batteries with different capacities.
■
Protect the product from: heat sources, direct sunlight, sub-
zero temperatures, moisture and wet conditions.
■
Do not make any changes to the product and do not attempt to
repair it. In the event of any damage, please contact our cus-
tomer service department.
Items Supplied
1 x pillow with cover, 1 x instructions
Check the product for any transport damage. If you fi nd any dam-
age, do not use the product, but rather contact the customer ser-
vice department immediately.
Inserting / Changing Batteries
PLEASE NOTE! Insert two 1.5 V batteries, AA type into the pillow
before you fi rst use it. These are not supplied with the product.
1. Open the small zip fastener along the side at the bottom of the
pillow.
2. Carefully pull out the battery compartment.
3. Slide open the battery compartment cover and remove it.
4. Check whether the contacts in the battery compartment and on
the batteries are clean, and clean them if necessary.
5. Remove any used batteries and insert two new 1.5 V batter-
ies, AA type into the battery compartment. Ensure the correct
polarity (+ / –).
6. Place the battery compartment cover on the battery compart-
ment and slide it shut.
7. Stow the battery compartment back in the pillow.
8. Close the zip fastener.
Replace the batteries when the power of the product starts to
wane.
Use
PLEASE NOTE!! The product switches off automatically after 10
minutes.
1. Place the pillow around your neck.
Tip: The fastener on the cords can be opened to make it easier
to place around your neck. To do this, press the locking lug in
the middle and pull apart the two parts of the fastener at the
same time. To close it, plug together and press together the two
parts of the fastener. They must engage audibly.
2. If necessary, adjust the fi t of the pillow by moving the fastener
along the cords. To do this, press together the fastener at the
sides and slide it along as you require.
3. To switch on the product, hold down the On / Off switch for ap-
prox. 3 seconds.
4. The product has two different modes. To switch between them,
press the On / Off switch for a short time.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
Article number: 05410
5. To switch off the product, hold down the On / Off switch for
approx. 3 seconds.
Cleaning and Storage
PLEASE NOTE!
■
Do not wash the product in the washing machine!
■
Do not soak the cover in water for more than 1 hour. The metal
parts inside the fastener could be damaged.
■
Do not use any sharp or abrasive cleaning agents or cleaning
pads to clean the product.
PLEASE NOTE! The cover of the pillow is washable. The pillow
must not be washed!
1. Open the large zip fastener on the bottom of the pillow.
2. Carefully peel the cover off the pillow. When you do this, make
sure that the On / Off switch is secured on the inside with the
Velcro fastener.
3. Wash the cover by hand, following the instructions on the
washing label. Do not use fabric softener. PLEASE NOTE!
Allow the cover to dry completely before it is pulled back on
the pillow.
4. Wipe down the pillow with a slightly damp cloth if necessary
and then dry it thoroughly.
5. Pull the cover over the pillow. When you do this, make sure that
the On / Off switch is in the right position.
6. Close the zip fastener.
7. Store the pillow with the cover in a dry place which is protected
from sunlight and is not accessible to children or animals.
Technical Data
Article number:
Model number:
Voltage:
ID of instructions: Z 05410 M DS V1 1218
Disposal
Dispose of the packaging material in an environmentally
friendly manner so that it can be recycled.
Batteries should be removed prior to disposal of the product
and disposed of separately from the product at a suitable
collection point.
The product is governed by the European Directive
2012/19/ EU on waste electrical and electronic equipment
(WEEE). Do not dispose of the product as normal domestic
waste, but rather in an environmentally friendly manner via
an offi cially approved waste disposal company.
Customer Service / Importer:
All rights reserved.
3
05410
C37-NM051
3 V DC (2 x 1.5 V battery, AA type)
✆
+49 38851 314650 *)
Instructions
Advertisement
