Spireon VehiclePath AT312 TT Manual

Spireon VehiclePath AT312 TT Manual

Asset tracking device

Advertisement

PRODUCT DESCRIPTION
AT312 TT
Asset Tracking Device
The AT312 TT is part of the VehiclePath asset
tracking line, which has the ability to track in real
time.
This unit has been specifically designed and
engineered to update on a daily basis (if not
connected to power) or on a 30-minute continuous-
tracking plan (if connected to power). When the unit
is connected to power, it will send an Auto Locate
every 24 hours.
If the unit is not connected to power, then it will
work off the internal battery and give an Auto
Locate every 8 hours. The device will automatically
generate Unauthorized Movement Alerts once it has
traveled 3 miles or more. It will continue to provide
an alert every 30 minutes until stationary.
The AT312 TT is built to withstand harsh environ-
ments and can function in up to 39 inches (1 meter)
of water. Its cellular and GPS antennas are
completely integrated. It also has an internal motion
sensor and internal battery.
TARGET MARKETS:
Trucking companies – local, long haul or intermodal
PRODUCT DIFFERENTIATORS:
Continuous tracking device
Internal battery back-up
Low monthly rate
©2012 Spireon, Inc.
OVERVIEW:
Low power consumption
(1mA in sleep mode)
Voltage monitoring and
low-battery notification
Over-the-air firmware
upgrade capability
Unauthorized Movement Alert
Power disconnect and
reconnect events
GSM Quad-band
(800/900/1800/1900 MHz)
Local Fleet Management

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VehiclePath AT312 TT and is the answer not in the manual?

Questions and answers

Summary of Contents for Spireon VehiclePath AT312 TT

  • Page 1 Its cellular and GPS antennas are completely integrated. It also has an internal motion sensor and internal battery. TARGET MARKETS: Trucking companies – local, long haul or intermodal PRODUCT DIFFERENTIATORS: Continuous tracking device Internal battery back-up Low monthly rate Local Fleet Management ©2012 Spireon, Inc.
  • Page 2 GPS: Internal LEDs Orange Solid Communication established with cellular network Orange Flash Looking for cellular network Green Solid Good GPS signal Green Flash Looking for GPS satellites Red Solid Connected to continuous power source Local Fleet Management ©2012 Spireon, Inc.
  • Page 3: Standard Installation

    Standard Installation INSTALLATION GUIDE STALLATION GUIDE WIRING DESCRIPTION: Getting Started etting Started Tools Required for Kit Contents: Installation: Wiring Diagram: Biased Low: Biased High: GPS Fleet Tracking...
  • Page 4: Mounting The Device

    Standard Installation Mounting the Device Preferred device placement is on forward-facing bulkhead near 7-way BEWARE! Handle 7-way with receptacle with wires pointed downward. care to keep wire connections intact – trailer wiring harness & components are typically attached to cover. number for the customer.
  • Page 5: Confirm Connectivity

    Standard Installation Locate Your Power Source Device requires constant 12 or 24 VDC power source to operate and recharge internal battery. Ground wire must be attached to an asset ground. located, use a digital voltmeter to locate an alternate power terminal.

Table of Contents