Table of Contents
Advertisement
WINCH BASE SCREEN
Touchscreen display winch base screen
TARGET numeric field. A numeric keypad will open; use it to key in a new numeric target. When you touch the
ENTER key on the keypad, the new value will be transferred to the TARGET field, and the keypad will close.
SPEED FIELD: (Variable-speed systems only) When the base screen opens up, the default speed will appear in
the SPEED field, below the TARGET field. The speed is expressed in feet per minute. To designate a new speed
value, touch the SPEED numeric field. A numeric keypad will open; use it to key in a new numeric target. When
you touch the ENTER key on the keypad, the new value will be transferred to the SPEED field, and the keypad
will close.
DEFAULT VALUES: There are four touchbuttons at the right of the screen that can be used to load values with a
single touch. The SUL button will load the Soft Upper Limit into the TARGET field. The SLL button will load the
Soft Lower Limit into the TARGET field. The POS AS TRGT button will load the current position into the TARGET
field. The DFLT SPD will load the default speed into the SPEED field (variable-speed systems only).
PRESET LOAD: The touchbuttons at the left of the screen (P-1 through P-8) are used to loads presets. When a
preset button is touched, the associated description will appear in the PRESET COMMENT area at the top of the
screen. The target and speed values for this preset will appear in the TARGET and SPEED fields.
SCREEN JUMPS: The buttons at the bottom of the screen (PRESET RECORD, PARAM PAGE, STATUS PAGE)
provide "jumps" to other screens and procedures in the control system. These are detailed in other sections of
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
Rev 1: February 13, 2007
SCENECONTROL 100 OPERATING INSTRUCTIONS
Each winch controlled by the system has a
base screen associated with it. An area at
the top right corner of the screen is blank if
the emergency stop system is healthy, or
will display the message ESTOP FAULT if
an emergency stop button has been
pressed. There are a number of functions
on this page
POSITION FIELD: This POSITION field in
the upper center of the screen displays the
current position of the set batten (in decimal
feet above the stage floor).
TARGET FIELD:
When the base screen
opens up, the current position will also be
displayed in the TARGET field, below this.
To designate a new target, touch the
www.jrclancy.com
PAGE 5
Advertisement
Table of Contents
