Cabinet (Front) Block - Sony NWZ-S763 Service Manual

Note: Follow the disassembly procedure in the numerical order given.
2-2.

CABINET (FRONT) BLOCK

JIG
When disassembling the set, use the following jig.
Part No. 9-913-402-33 Tool for Disassembly
Left side:
cabinet (front) block
panel (rear) block
2 Insert the jig in the gap between cabinet
(front) block and panel (rear) block.
Then slide it to arrow direction to remove
claws of cabinet (front) block.
Note 2: Take care because the plate bends outside
if the cabinet (front) block is rotated.
Right side:
2 Insert the jig in the gap between cabinet
(front) block and panel (rear) block.
Then slide it to arrow direction to remove
claws of cabinet (front) block.
Note 5: When installing cabinet (front) block, the position
of switch and knob (hold) is set and installed.
1 two screws (PTP1.4)
Note 1: When you tighten two screws (PTP1.4),
3 four claws
cabinet (front) block
panel (rear) block
knob (hold)
switch
NWZ-S763/S763BT/S764/S764BT/S765
tighten according to the following.
tightening tor ue m
– Rear bottom view –
Note 2: Take care because the plate bends outside
– Front bottom view –
8 cabinet (front) block
4
– Front bottom view –
3 three claws
if the cabinet (front) block is rotated.
6 adhesive sheet (cap)
Note 4: Remove taking care not to
damage the cabinet (front)
block.
7 claw
5 adhesive sheet (chassis cover)
Note 3: Remove taking care not to
damage the cabinet (front)
block.
7