The Container Store Linea Leaning Desk Assembly Instructions

Linea
Leaning
Desk
Hardware
(H1) x 4+1 extra long dowel
(H2) x 4+1 extra short bolt
(H3) x 2+1 extra binding screw
(H4) x 2+1 extra long bolt
(H5) x 4+1 extra short dowel
(H6) x 2 Allen wrench
(H7) x 4+1 extra 1/2" pan head screw
(H8) x 6+1 extra 1" pan head screw
(H9) x 2 mending plate
(H10) x 4+1 extra flathead screw
(H11) x 1 left bracket
(H12) x 1 right bracket
Anti-Tip Hardware
(H13) x 1 38mm wall screw
(H14) x 1 wall anchor
(H15) x 1 pan thread screw
(H16) x 1 wall strap
WARNING —
Severe injury may occur if furniture tips over. Never allow children to climb or play on this product. Place heavier items on lower shelves
as far back as possible and never overload. Follow all instructions listed in this assembly guide and always use the anti-tip hardware to mount unit to a wall.
Assembly Instructions
Please read all of the information below before you begin.
Thank you for purchasing the Linea Leaning Desk. The contents included in the box are
listed below and on the next page. Please take the time to identify the hardware and
desk components. As you unpack and prepare for assembly, place the contents on a
carpeted or padded surface to protect them from damage.
Required Assembly Tools
Use a mallet or hammer to tap the dowels into place. A Phillips screwdriver, drill and 17/64" drill bit are
required to complete assembly of the anti-tip wall strap.
(H1)
(H5)
(H9)
(H13)
Drill &
17/64" Drill Bit
(H2)
(H3)
(H6)
(H7)
(H10) (H11)
(H14) (H15)
Hammer or
Mallet
Phillips Screwdriver
(H4)
(H8)
(H12)
(H16)
©2013 The Container Store ® Inc. All rights reserved. 18023 3/13