Westfalia 53 58 98 Instruction Manual page 3

With the Westfalia gutter protection you
can forget all this after you once
installed it. Just flush your gutters every
few years and you are done.
Stainless steel sheets and durable clips
ensure a long service life.
Make sure that the cover fits your rain
gutter. The cover is available in 10,
12.5, and 15 cm wide.
Mounting clips are included with the
package. The clips are made of metal
and are 18 cm long.
1. Cut the covers down to the right
length with plate shears or a similar
tool. Be careful, the edges can be
very sharp.
Always wear gloves during this
work.
2. Clip the mounting clips into the
holes in the cover with the tongues
in regular intervals. The hook-
shaped part of the clips must reach
over the cover edge.
3. Push the cover under your roofing
and clip it to the rolled edge of the
gutter by means of the clips. Water
from the roof must be able to drain
into the gutter, but leafs shall be
kept out.
Always take precautions against
falling off the roof while involved
in this work.
Dear Customers
Attention! Make sure the gutter cover
is lying on the rolled front edge (A) of
the gutter. On the opposite side of the
folded edge (B), the gutter will just
butt against the edge.
Make sure the clips will hook under
the rear folded edge as far as
possible.
III
A
B