Mpc2000D Communications; Mpc2000D Pc Software; Mpcset Software; Mpc2000D Engineering Pc Software - P&B MPC2000D Manual

10. MPC2000D Communications

The MPC2000D in addition to its very comprehensive protection has been equipped with a very powerful data
communications system. The relay provides high speed data acquisition to supervisory computers to form a complete
motor management system. Each MPC2000D can be connected to an isolated data highway using RS485
communications. Up to 32 MPC2000D units can be connected to each data highway.
For further information on the communication of the MPC2000D phone us for our booklet at
Manchester 0161-230-6363.

11. MPC2000D PC Software

11.1 MPCSET Software

.
All of the MPC2000D setting parameters mentioned above can be viewed and changed through the use of the
MPCSET Software offered by P & B Engineering. It is designed to configure large numbers of units quickly as well
as storing and printing the MPC2000D setting parameters.
For further information on the communication of the MPC2000D phone us for our booklet at
Manchester 0161-230-6363.

11.2. MPC2000D Engineering PC Software

The Engineering Workstation Package offered for the control and monitoring of the P & B Engineering Co.
MPC2000D Motor Protection Controller is based on the P-CIM Process Monitoring & Control software package.
For further information on the MPC2000D Engineering PC Software phone us for our booklet at Manchester
0161-230-6363.

12. MPC2000D Flash/Constant Messages

The following Flash and Constant messages are displayed by the MPC2000D LCD :
DATA SAVED OK
stored to the EEPROM memory
WRONG DATA SAVEDThis Flash message is displayed if an error has occurred in attempting to save a setting
parameter to the EEPROM memory.
WRONG PARAMETERS
found to be incorrect. This may occur if installing a new EEPROM in the MPC2000D.
UNAUTHORISED ACCESS
input is open this Flash message is displayed. This message will also be displayed if an attempt is made to
reset a fault for which the panel reset has been disabled.
RESET THERMAL CAPACITY ???
Authorised input closed and if the reset button is pressed again whilst the message is displayed, the Thermal
Capacity will be re-set to Zero.
THERMAL CAPACITY RESET PERFORMED
operation has been successfully performed.
MPC2000D
This Flash message is displayed after a setting parameter has been correctly
This message is displayed after power up if the EEPROM parameter check sum is
If an attempt is made to change or store a setting parameter whilst the Authorise
This Flash message is displayed when the reset key is pressed with the
Issue 2 22/4/98
This Flash message is displayed after the above
Page 31