Check The Meter Display; Ontour N Ext Meter; Target Ranges - Contour Next User Manual

Your C n test strip
ontour ext
Grey Square End:
Insert this end into the test strip port
Sample Tip: Blood sample pulled in here

Check the Meter Display

Press and hold the OK button until the meter turns on, about
3 seconds.
The screen displays the Power On Self Test.
All symbols on the screen and the white strip
port briefly light up. It is very important to verify
88 88 88 88 88
that 8.8.8 displays fully and that the white light
888
from the test strip port is visible.
If there are missing characters or if the strip
port light is a colour other than white, contact
Customer Service. This may affect the way you
see your results.
6
GETTING STARTED
NOTE: Your meter comes with a pre-set time, date, and target range.
You can change these features in Settings. See Settings on page 37.

Target Ranges

The meter compares your blood glucose results with a Target Range
(for example, 3.9 mmol/L–7.2 mmol/L) to let you know if your test result
is above, in, or below your Target Range.
10 45 26 11 18
Above Your Target Range.
111
10 45 26 11 18
In Your Target Range.
56
10 45 26 11 18
Below Your Target Range.
36
You can change Target Ranges in Settings
See Settings on page 37.
C n blood glucose monitoring system
ontour ® ext
.
7