HP 3400B User's And Service Manual page 34

Chapter 2 Calibration Procedures
Adj ustment Procedures
Full Scale Pointer Adjustment
This procedure shows you how to manually adjust the position of the
meter pointer for full scale readings. When properly adjusted, the meter
pointer should be aligned with the full scale marking on the right side
of the meter scale.
(see
This adjustment is made on the
which is located on the main circuit board to make the adjustment
R330
below).
�§
-C)- c::: :J
-C)-
-=
-<J-
1
HP 3400B:
Select the
2 Calibrator: Select a
·Wideband" output on the Fluke
3
Allow one minute for the meter pointer to stabilize.
4 Remove the top cover from the HP
only
that you do rwt remove the side or bottom covers). Adjust
until the meter pointer is aligned with the full scale marking on
the right side of the meter scale.
32
0. 1
volt range at
-=
-c::: :>-
�
-0- -<J-
0. 1
volt range.
0. 1 I
volt ac signal at
5700A).
3400B
.
1 kHz.
You will use
Scale
Full
Pointer Adju stment (R330)
:::::::
kHz (use the
(it is important
R330
•
•
•
� I
•
•
•
•
•
•