Horizontal Module Removal (Fig. 5-9)
To remove module:
1. Remove tw o screws holding module.
2. Unsnap the POWER switch extension from clip on
Power switch shaft.
3. Pull plug-in module straight away from main module
interface connector.
To install module:
1. Place module interface plug over main module inter
face connector and press firm ly into place.
2. Snap POWER switch extension into clip on POWER
switch shaft. (Yokes on plastic clips must be aligned be
fore extension can be snapped into place).
3. Secure module w ith tw o screws.
Board Locations
Figure 5-10 shows the general location o f the circuit
boards in the B2 Module to facilitate board replacement.
REV. A, OCT 1975
TO REMOVE MODULE PULL
STRAIGHT AWAY FROM MAIN
MODULE INTERFACE CONNECTOR
Fig. 5-9. Horizontal Module removal.
Maintenance— 455/A2/B2
SCREW
POWER SWITCH EXTENSION
ROD SNAPS INTO PLASTIC
RETAINER ON POWER SWITCH
A14
B TIMING
SWITCH BOARD
Fig. 5-10. Circuit board locations.
1907-47
1 9 0 7 -4 8
5-11