Dirna bycool blue line REVOLUTION 12 V. ADR Mounting Instructions page 40

dirna
REVOLUTION , s.a.
EN
Detailed instructions
about power supply installation
1
Power Cable
1- Run the power cable of the equipment to the vehicle battery, sticking the plastic supports on the rear
part of the cab and attaching it with cable ties; then with the cab folded forward pass the cable through
the lower area and fasten it with clamps and M4 screws; and as far as the battery with cable ties; the same
pitch should be used as that of the original cable. (Clean the area well before sticking the plastic supports).
On connecting the equipment to the battery this will automatically carry out a test on all its leds, and will
switch off.
IMPORTANT: Due to the complex electronic adjustment system of the vehicle, power must
be taken directly from the battery of the vehicle, not from any other point which services other
accessories, remembering not to reverse the polarity when carrying out the connection (2). If
the connection is reversed serious damage can be caused to the electronics which is not covered
by the guarantee.
IMPORTANT:
To start the machine consult the User Manual.
2 2
+
-
40