Advertisement
Quick Links
QUICK START GUIDE
WP-120 Series
1
First Use
Power
ON
High
This device is only compatible with voltages of 100-240VAC, 50/60Hz
Fill reservoir with
warm water and
replace it firmly
on the base.
Turn pressure to high, point tip
into sink, turn power switch ON
until water flows. Turn OFF.
Insert tip firmly
until it clicks
into place.
©2019 Water Pik, Inc.
Advertisement
Related Manuals for Waterpik Water Flosser WP-120 Series
Summary of Contents for Waterpik Water Flosser WP-120 Series
- Page 1 QUICK START GUIDE WP-120 Series First Use Insert tip firmly until it clicks into place. Fill reservoir with warm water and replace it firmly on the base. Power High Turn pressure to high, point tip into sink, turn power switch ON until water flows.
- Page 2 QUICK START GUIDE WP-120 Series Water Floss Power Turn power ON. Start on Close lips enough to prevent low pressure. Place tip in splashing while still allowing mouth. Lean over sink. water to flow from mouth into sink. Increase pressure to your liking.