Install System Memory - Abit IG-80 Series User Manual

2-4

2-3. Install System Memory

This system board provides two 184-pin DDR DIMM slots for DDR 400/333 memory modules with
memory expansion size up to 2GB.
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM2)
NOTE: Usually there is no hardware or BIOS setup require after adding or removing memory modules,
but you will have to clear the CMOS memory first if any memory module related problem occurs.
Power off the computer and unplug the AC power cord before installing or removing memory modules.
1. Locate the DIMM slot on the board.
2. Hold two edges of the DIMM module
carefully, keep
connectors.
3. Align the notch key on the module with the
rib on the slot.
4. Firmly press the module into the slots until
the ejector tabs at both sides of the slot
automatically snaps into the mounting notch. Do not force the DIMM module in with extra force as
the DIMM module only fit in one direction.
5. To remove the DIMM modules, push the two ejector tabs on the slot outward simultaneously, and
then pull out the DIMM module.
ATTENTION: Static electricity can damage the electronic components of the computer or optional
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
IG-80 Series
256MB, 512MB, 1GB
256MB, 512MB, 1GB
Total System Memory
away of touching
Memory Module
its
Chapter 2
Total Memory
256MB ~ 1GB
256MB ~ 1GB
256MB ~ 2GB