Faults - Caroma Smart Command Eco Valve Installation & Operational Manual

11. Faults

11. Faults
Alarm text
Fault of shut-off valve
Fault of
network connection
Suspected leak:
volume-based leakage
Suspected leak: time-
based leakage
Suspected leak: flow-
based leakage
Suspected leak:
Microleakage
Fault
Flow sens or
Cause
The shut-off valve cannot be activated. Maybe
due to dirt or a defect of the motor or of the
limit switch. Attention: Limited leakage
protection!
There is no connection to the network.
The maximum admissible volume is exceeded.
Potential volume-based leakage.
The maximum admissible time has been
exceeded. Potential time-based leakage.
The maximum admissible flow rate has been
exceeded. Potential flow-based leakage, for
instance due to a pipe burst.
The maximum admissible volume has been
exceeded. Potential microleakage, e.g. in a
cistern.
No turbine impulses have been registered over an
extended period of time. Maybe the turbine or the
sensor is contaminated or defective.
Attention: Limited leakage protection!
Correction
Please check the function by
operating the shut-off valve
manually.
Please establish a connection to the
network.
Please eliminate the leakage or
adjust the protection level.
Press the button on the device to
open the shut-off valve. It is possible
to perform this action via the Smart
Command App.
Please eliminate the leakage or
adjust the protection level.
Press the button on the device to
open the shut-off valve. It is possible
to perform this action via the Smart
Command App.
Please eliminate the leakage or
adjust the protection level.
Press the button on the device to
open the shut-off valve. It is possible
to perform this action via the Smart
Command App.
Please eliminate the leakage or
adjust the protection level.
Press the button on the device to
open the shut-off valve. It is possible
to perform this action via the Smart
Command App.
Open a draw-off point and check
whether the control displays any
(LED) turbine impulses. Contact
Caroma service.
23