4
General Operation
4.1
Crimping an OT Terminal
Pay attention not to damage the core wire when stripping a cable.
The cavity formed after the conductor crimp strip of the OT terminal is crimped must wrap the
core wires completely. The core wires must contact the OT terminal closely.
Wrap the wire crimping area with heat shrink tubing or PVC insulation tape. The following figure
uses heat shrink tubing as an example.
When using the heat gun, protect devices from being scorched.
Insulation layer
Core wire
4.2
Installing the Tube Fittings (Using AC OUTPUT as an Example)
The tube specifications should comply with the waterproof connector specifications. For example,
for a 2 in. waterproof connector, prepare a 2 in. tube. The tube appearance shown in the following
figure is for reference only. The actual tube prevails.
Tube
Nut
Fitting
Heat
gun
Conduit
Hydraulic
pliers
Diameters of the bottom cable holes
7
Heat
shrink
tubing