Troubleshooting - Greenheck SQ Installation, Operation And Maintenance Manual

Direct drive square mixed flow inline fans
Table of Contents

Advertisement

Troubleshooting

WARNING
Before taking any corrective action, make certain unit
is not capable of operation during repairs.
PROBLEM
CAUSE
Wheel unbalance
Excessive noise
Wheel improperly aligned and
or vibration
rubbing
Foreign objects in wheel or
housing
System resistance too high
Unit running backwards
Reduced airflow
Excessive dirt buildup on wheel
Improper wheel alignment
®
For Vari-Green
motor troubleshooting, refer to the Vari-Green Motor Installation, Operation and Maintenance
Manual.
®
AVERTISSEMENT
Avant d'entreprendre toute action corrective, s'assurer
que l'appareil ne pourra pas fonctionner durant les
réparations.
CORRECTIVE ACTION
Clean all dirt off wheel. Check wheel balance, rebalance in
place if necessary.
Center wheel on inlet, see Figure 3.
Remove objects, check for damage or unbalance.
Check system: Proper operation of backdraft or control
dampers, obstruction in ductwork, clean dirty filters.
Correct. See Wheel Rotation on page 4.
Clean wheel.
Center wheel on inlet, see Pre Start-Up Checks and Figure 3.
Square Mixed Flow Inline Fans
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sq-16Sq-18Sq-20Sq-22Sq-24Sq-27 ... Show all

Table of Contents