Getting Started; Version Information; Hardware Source Requirement; Preparation - CooCox CoLinkEx_LPC11C14 User Manual

3. Getting Started

3.1 Version Information


Firmware: 0.4

Driver: 1.2.0（or 1.2.1）

Software:

CoIDE 1.4.0 or higher

CoFlash 1.4.0 or higher

MDK 4.03(or higher) plus CoMDKPlugin1.4.0 or higher

3.2 Hardware Source Requirement

When you use CoLinkEx_LPC11C14 EVB Kit, The PC is required to use the following
sources:

CPU: 2.0GHz (at least)

Memory: 512M (at least)

USB Interface: 1 (at least)

Serial Line interface use COM1

Operation System: Windows XP/Windows Vista/Win 7

Software need: CoIDE, MDK, IAR(with CoMDKPlugin, CoIARPlugin)

3.3 Preparation


Install CoIDE or the corresponding Plugin

Update the firmware and install the driver,
Use
 Jumpers' setting: JP1, JP2 both OFF.

USB Connection: Using USB cable, one end plugged into the Mini USB port on
the board CoLinkEx (J1), the other end connected to PC.

If serial communication is needed:
Serial Connection: Connect com of board and the COM of PC through serial port
cable.
Serial Port Receive Settings: In the PC, run HyperTerminal serial communication
program, select the serial port used and set the following parameters (to set
status: Baud rate (115200), data bits (8 bits), stop bits (1 bit), parity bit (no ), data
flow control (no)).

If CAN Communication is needed:
Refer to: CoLinkEx Installation and
12