Advertisement
ASSEMBLY
To install the Backrest
3
pegs at the bottom of each end of
the Back into the holes in the top
of the back end of the edge pieces
of the seat. Secure by inserting a
E
Bolt
through the hole near the
bottom of either side of the
Backrest and into each bench Side.
H
Then insert a Bolt
through the
hole drilled at the back of each
arm and into the aligned hole at
each side of the Back. Tighten all
hardware, being careful not to
over-tighten.
Hardware Used:
E
Bolt (M6x40) x2
H
Bolt (M6x80) x2
4
On a nonabrasive surface,
carefully turn the bench upside-
down. Locate the hole near the
back end of the seat divider.
F
Insert 1 Bolt
to join the Seat to
the Backrest. Tighten the Bolt
using the Hex Wrench, being
careful not to over-tighten. After
checking that all hardware is
secure, turn the bench back
upright.
Your Kingsmen Loveseat Bench is
fully assembled!
Hardware Used:
F
Bolt (M6x60) x1
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
A
, insert the
3
A
H
E
2
F
1
5
Advertisement
