Roland V-Synth Book page 35

Hide thumbs Also See for V-Synth:

Table of Contents

Activate oscillator 2, touch the OSC2 pad and the Pitch tab

so that the oscillators slowly "beat" against each other. With two oscillators the sound is

now much thicker, but pushing the Bender only adds vibrato to oscillator 1 at the

moment. Go back to the Common / Matrix Ctrl page and select the Control 3/4 tab

. Set the same values in Control 3 as in Control 1, but for oscillator 2 instead:

Source = CC01

Destination1 = 040:OSC2-LFO-PCH

Sens = +14

Destination2 = 39:OSC2-LFO-RATE

Sens = +2

Play the keyboard and push the Bender. You should be able to hear that the LFOs in both

oscillators have the same rate, but also that they are not synchronized - one can start

later (in it's cycle) than the other. To remedy this, go to each of the oscillator LFO pages

in turn and switch on Key Sync.

Now let's create a control for the amount of Reverb. Select KNOB1 as Control 4 source

, set Destination1 to 075:REV-SEND

up the C1 knob now, you won't hear any reverb because it hasn't been switched on yet.

Touch the Effect pad

(and the Routing tab if necessary) then set Reverb Type to

06 (Hall3)

. Save your refined version of "Simplicity"!

. Change Fine to +5

and sensitivity to +63. Even if you turn

Table of Contents